Stator Crankcase Cover Gasket for Yamaha YZF R6 1999-2002
Stator Crankcase Cover Gasket for Yamaha YZF R6 1999-2002
SKU:RM08015
Free shipping over £150. Terms apply
Couldn't load pickup availability
Stator Crankcase Cover Gasket for Yamaha YZF R6 1999-2002
Brand new side cover and stator gasket - part RM08015 - replaces Yamaha 5EB-15451-00-00
The stator crankcase cover gasket is the seal between the engine case and the stator side cover. It has two jobs: it keeps engine oil sealed inside the crankcase, and it keeps water and road dirt away from the stator windings and the rotor that sit behind the cover. On the first-generation YZF R6 the cover comes off for any charging system work - fitting a new stator, inspecting the rotor, or chasing a charging fault - and the gasket should be renewed each time. Once a gasket has been torqued down it takes a permanent set, and refitting a used one is the most common reason a cover starts weeping oil afterwards.
This is a brand new side cover and stator gasket cut to the original Yamaha pattern, so every bolt hole and oil passage lines up with the factory case and no trimming, no sealant bead and no modification is required. It replaces Yamaha part number 5EB-15451-00-00 and is covered by a one year limited warranty. The item photographs on this listing are accurate representations of the gasket supplied, so if you are in any doubt, compare them directly against your original part before ordering. This is a ride specific part - confirm the model and year before you buy, and have the cover refitted and torqued properly to avoid leaks.
Key Features
- Brand new side cover and stator crankcase cover gasket
- Direct replacement for Yamaha part number 5EB-15451-00-00
- Cut to the original pattern - no trimming or modification needed
- Ride specific to the Yamaha YZF R6, 1999 to 2002
- One year limited warranty
- Product photographs show the actual item supplied
- The correct part to fit whenever the stator cover is removed
Technical Specs
| Specification | Detail |
|---|---|
| Part number | RM08015 |
| Part type | Stator crankcase cover gasket |
| Condition | Brand new |
| Fitment type | Ride specific |
| Model covered | Yamaha YZF R6 |
| Coverage span | 1999-2002 |
| Warranty | 1 year limited |
Vehicle Fitment Guide
| Make & Model | Years |
|---|---|
| Yamaha YZF R6 | 1999-2002 |
OEM Part Number Cross Reference
Aftermarket replacement. OEM part numbers are listed for reference only.
| Part Number | Manufacturer / Brand |
|---|---|
| 5EB-15451-00-00 | Yamaha |
Frequently Asked Questions
Will this fit without modification?
Yes. It is cut to the original Yamaha pattern for the 1999 to 2002 YZF R6, so the bolt holes and oil passages line up with the case exactly as the factory gasket did. No trimming and no modification is required.
What is included?
One side cover and stator crankcase cover gasket. Cover bolts, seals and the stator itself are not included.
How do I know my old gasket needs replacing?
An oil weep below the stator cover is the usual sign - a wet, dirt-caked film down that side of the engine, or oil gathering on the lower lip of the cover. A gasket that tore on removal, that has hardened with heat, or that has taken a permanent set from being torqued down should always be replaced rather than refitted.
How can I confirm it suits my R6?
Check the number on your original part against 5EB-15451-00-00 in the cross reference table above, and compare the outline of your old gasket with the product photographs. This gasket covers the 1999 to 2002 YZF R6; later R6 models use a different cover and a different gasket, so the OEM number is the surest check.
Share
