This tilt and trim motor is a direct replacement for Yamaha 50HP to 115HP outboard engines. It is built to OEM specifications, matching the original mounting flange, so it fits and functions as a like-for-like replacement.
The original equipment motor used a 3-wire connection, and this replacement motor uses a 2-wire connection on a 70.5mm mounting flange diameter, so please check your wiring configuration matches before ordering.
Key Features
- 12 volt operation for full power trim and tilt function
- 2-wire connection (OE was 3-wire)
- 70.5mm mounting flange diameter
- Direct OEM fit and finish
- 12-month warranty as standard
Technical Specs
| Specification |
Detail |
| Voltage |
12V |
| Wires |
2-wire (OE was 3-wire) |
| Mounting Flange |
70.5mm diameter |
Vehicle Fitment Guide
| Make & Model |
Years |
| Yamaha 50-115HP Outboard Engines |
Not specified by supplier |
OEM Part Number Cross Reference
Aftermarket replacement. OEM part numbers are listed for reference only.
No OEM cross reference is published for this part.
Frequently Asked Questions
Will this fit without modification?
Yes, in terms of the mounting flange and housing. Note the wiring changes from the original 3-wire setup to a 2-wire connection on this replacement motor, so check your harness before fitting.
What is included?
You receive the tilt and trim motor unit only, ready to install into your existing tilt and trim assembly.
How can I tell my old motor has failed?
Common signs include the engine failing to tilt or trim, a humming noise with no movement, or slow and intermittent operation, usually caused by worn brushes or gears inside the original motor.
Why does this have fewer wires than my original motor?
The original equipment motor used a 3-wire connection, but this replacement is built with a 2-wire connection. Function is the same, but you will need to check your harness terminals match before fitting.
Dispatched from the UK · 12-month warranty · Fitment support from our technical team
